• Same as Wall End Display, except uses Contoured End Decks, Contoured End Shelves, and Contoured Base Bracket End Trims
• Order Shelves separately
• Order Gap Filler separately when unit is wider than Island
• Actual width of unit equals nominal width plus 2″
• Base End Trim and Closed Base Front available in CHR only

TO ORDER OTHER BACK STYLES

• Delete the Peg Front and/or Marteck Rear Back(s) and replace with the desired Back(s)
• If Slotwall Backs desired, order required Rails

TO ORDER DECKS WITH ALUMINUM MOLDING

• Delete Standard Deck and add Deck with Molding

HIGHLIGHTS

• Converts existing sections into multiple width sections
• Works with standard or heavy duty systems
• Accepts most standard Lozier Shelves and Accessories
• Order Heavy Duty Versa when existing section is Heavy Duty
• Versa Half Splicer ordered separately as needed to splice Hardboard Backs
• Backs must be ordered separately
• Regular and Heavy Duty Versa supports standard load capacity of a 48”W system – 12,000 in-lbs

INCLUDES

• Versa Uprite
• Versa Spanners
• Versa Top Rail
• Half Splicer Rail (where applicable)
• Versa Bottom Spanner
• Bottom Rail Support

VERSA SYSTEM CONFIGURATIONS

• Available 36”H to 96”H
• If using Versa Slotwall, can use on Versa side only. Slotwall is not compatible on backside of Versa Section
• Order Versa Half Splicer for Hardboard Backs on Sections 78”H and taller
• See STD Hardboard Backs for ordering information
• See Versa Slotwall VBE Backs for ordering information

VERSA SYSTEM 4′ CONFIGURATIONS

VERSA SYSTEM 3′ CONFIGURATIONS

• Top of Panel sits flush with Flush Merchandising Panel (FMP)
• Can be set flush or inline for desired application
• Not compatible with End Merchandising Panels (EMP)

• For inline applications on a Wall End Display Deck, Contoured End Display Deck or Island Section Deck
• A Wall End Display Rail (WEDER) is required, order separately
• See Installation Instructions for load capacities and limitations

INCLUDES

• Upper Connector
• Lower Stabilizer
• Hardware Pack