• 50”Wx24”D Marteck top

• S-Series Storage Sections must be stabilized with either Crossbraces or Back Panels
• Crossbraces (or Back Panels) are required on end sections of each run and every fourth section in between for stabilization
• See diagram below for minimum recommended placement of Crossbraces per run
• Back-to-back runs can share Crossbraces if Uprites are securely connected with S-Series Storage Screws (#SS2221)
• If section height is over 96″, the part number below includes two sets of Crossbraces for the section (one lower and one upper Crossbrace)

MINIMUM BRACING REQUIREMENTS DIAGRAM

• Pre-assembled, no loose hardware needed
• Easy to install and reposition, adjusts in 2″ vertical increments

PARTICLEBOARD S-SERIES STORAGE SHELF

• 5/8″ industrial grade particleboard
• Regular Duty reinforced with 3/4″D x 3/4″H galvanized steel channels
• Heavy Duty reinforced with 1 1/4″D x 3/4″H galvanized steel channels
• Seal coated particleboard for durability and stain resistance
• Regular Duty – Evenly distributed load of 500 lbs per Shelf
• Heavy Duty – Evenly distributed load of 600 lbs per Shelf

WIRE GRID S-SERIES STORAGE SHELF

• 1″ x 6″ Wire Grid
• Reinforced 1 1/4″D x 3/4″H galvanized steel channel
• Provides for light penetration, water flow through for sprinklers and cleanliness
• Evenly distributed load of 500 lbs per Shelf

• Made of galvanized steel posts
• Two Styles: Open and Closed Uprites
• Open Uprite has galvanized steel Uprite braces (Pat. # 6,085,918)
• Closed Uprite has 5/8” unfinished particleboard panel between two steel Uprite posts
• Shelf lances are 2” on center
• One assembly required for each section and at the end of each run