• One-piece Uprite Frames for units 48” – 120”
• Uprite post slotted on face, allows shelf adjustment 2” on center
• Square holes punched on sides of Uprite post for accessories
• Accessory holes punched 6” on center on face of Uprite also aid beam placement
• Top Caps included on each Uprite
• One Frame required for each section, plus one at end of each run
• To provide increased protection under harsh shipping conditions add “SPC” to part number for additional packaging
• Floor Anchors, Floor Protectors, or Back to Back Connectors may be ordered separately
• Evenly distributed load of 10,000 lbs per Uprite Frame at 48″ max. Beam spacing, vertically

REINFORCED UPRITE FRAME

• “RE” Frame available in 72” – 120”H and all depths (lower Frame only on 132” – 192”)
• For use with hand loader/stacker
• Reduces chance of Frame damage
• Channel welded inside each post in lower 48”
• Welded foot plate for anchoring, 1/2” hole

Save

• Uprite post slotted on face, allows shelf adjustment 2” on center
• Square holes punched on sides of Uprite post for accessories
• Accessory holes punched 6” on center on face of Uprite also aid beam placement
• Top Caps included on each Uprite
• One Widespan Uprite Frame required for each section, plus one at end of each run
• To provide increased protection under harsh shipping conditions add “SPC” to part number for additional packaging
• Floor Anchors, Floor Protectors, or Back to Back Connectors may be ordered separately
• Two-piece Widespan Uprite Frame provides same rated load as One-Piece Widespan Uprite
• Evenly distributed load of 10,000 lbs per Uprite Frame at 48″ max. Beam spacing, vertically

REINFORCED UPRITE FRAME

• “RE” Frame available in 72” – 120”H and all depths (lower Frame only on 132” – 192”)
• For use with hand loader/stacker
• Reduces chance of Frame damage
• Channel welded inside each post in lower 48”
• Welded foot plate for anchoring, 1/2” hole

Save

• Available in both Heavy Duty and Regular Duty
• Integral Beam connectors
• Tilt-in design, no fasteners or locking clips required when used with Shelf Support (WSSS)
• Minimum of four beams required per section: one each top, bottom, front and back of section
• Requires Shelf Supports to tie Beams together
• Minimum one Shelf Support on 48”W and 60”W Beams
• Minimum two on 72”W, 84”W and 96”W, or must use Locking Clips

Save

• Available in Heavy Duty and Regular Duty
• Rotates into place inside Beam body
• Number of Supports required varies based on required load

• Heavy gauge steel angle fastens Uprite Frame to floor
• Required when height-to-depth ratio exceeds 6 to 1
• Use as required to meet seismic anchoring specifications
• Uprite mounting hardware included
• Anchor bolt not included

• Use for all beam locations other than in the top slot of the Uprite
• Snap into Uprite slots to prevent Beam movement
• Use at each end of Beam or where two adjacent Beams share same slot
• Must use when not using Shelf Supports (WSSS)